Eaton ePDU G3 - Uploading Binary File (HTTP); Upgrade Firmware and Refresh Web Pages (HTTP)

Web Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 1 www.eaton.com/ePDU 122
Enable/Disable the Telnet Interface
NOTE Selecting a console type on the Security page makes the corresponding port entry
box active. 
Not selecting a console type makes the corresponding port entry box inactive and
grayed-out.
1. Access the Web interface and log in.
2. Under Network and Securit
y, select Global. The Security page displays.
3. In the Ports Settings panel, select Te
l n e t from the Console drop-down list to enable the Telnet interface,
or select Disabled to disable it.
4. If enabled, the Telnet Port entry box is active. Type the port number.
5. Click Save.
6. Open the System submenu in the Settings menu.
In the Network Management Card panel, click Restart
network management card to restart the ePDU Network Management and Control (eNMC) module.
Enable/Disable the SSH Interface
1. Access the Web interface and log in.
2. Under Network and Securit
y, select Global. The Security page displays.
3. In the Ports Settings panel, select SSH from the Conso
le drop-down list to enable the SSH interface, or
select Disabled to disable it.
4. If enabled, the SSH Port entry box is active. Type the port number.
5. Click Sa
ve.
6. Open the System submenu in the Settings menu.
In the Network Management Card panel, click Restart
network management card to restart the ePDU Network Management and Control (eNMC) module.
Enable/Disable FTP
1. Access the Web interface and log in.
2. Under Network and Securit
y, select Global. The Security page displays.
3. In the Ports Settings panel, check the FTP En
able check box to enable FTP, or uncheck the box to disable
it.
4. Click Sa
ve.
5. Open the System submenu in the Settings menu.
In the Network Management Card panel, click Restart
network management card to restart the ePDU Network Management and Control (eNMC) module.
Set Authentication Mode
1. Access the Web interface and log in.
2. Under Network and Securit
y, select Global. The Security page displays.