Eaton ePDU G3 - Environment Sensor Settings; Active Alarms Review

Web Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 1 www.eaton.com/ePDU 98
l
Logs and Notifications
-Logs
- Trap Notification
- Syslog
l
Settings
See NOTE 2
- User-Defined Groups
- Access Accounts
-System
- Date & Time
l
Network
-TCP/IP
-SNMP
-Security
l
Global
l
LDAP
l
RADIUS
NOTE 1 Menu selections for ePDU [0], [1], [2], or [3] only display if the ePDUs are configured
in a daisy-chained configuration. If provided, selecting either ePDU [0] or ePDU [1],
[2], or [3] displays the Overview page for the specified ePDU only.
NOTE 2 T
he Settings menu is different from the Settings button. Selecting the Settings
button on any power management page displays a separate window that allows you
to change settings, such as alarm thresholds.
NOTE 3 See “Access Privileges” on page 99 for more information about levels of access
pr
ivileges.
Power Management
Use the Power Management menu selections to see up-to-date operating measurements on the ePDU
Overview page. This page provides the present readings for the ePDU that is reporting data. (If ePDUs are
daisy-chained, you can select to see Host or Device ePDU Information.) The readings are reported per phase
and, for 3Ph ePDU models, all phases. This page includes data such as current, voltage, and crest factor. The
outl
et icons are green if the outlet is on and red if the outlet is off. Roll over the icon to see the outlet type and
status.
You can select the Outlets or Groups page to manage outle
ts or groups of outlets. These pages provide present
measurements or readings such as current or active power. You can set measurement thresholds for alarm or
warning notifications as well.
The Environment menu selection provides humidity and temperature data if you have an EMP installed. You
can
set measurement thresholds for alarm or warning notifications as well. It also provides open or closed
status for two dry contacts.
You can check current alarms on the Active Alarms page to
see a list of alarms by date, time, and description.
See “Maintenance and Alarms” on page 127 for a list of alarms.
Logs & Notifications
Use the Logs & Notifications menu selections to see a list of the most recent events (Logs page). You can set
trap receivers (Trap Notification page) and you can also view Syslog information.