Eaton FS-4205B - Page 26

DISASSEMBLY AND REASSEMBLY
SHIFTING CONTROLS
Shift Bar Housing Assembly (cont.)
s. Install intoOOck bails, deten1 balls and springs in the
following seQUence ; position balls in the reverse bght
swrleh oore and i nstaJl 1s1 -r eversedetentspnngand bal l.
?OStbOn (2) balls In adjacent cross bore and instal l 2nd·
6. Seal the 1st rQVQrse actuatOf In the sh 1h bar housing ,
over 1he actuator pll/01 ptn , as shown
3rd detent spring and ball Position (2> balls ui adjacent
cross bore and insta ll deten1 spnr.g and ball
N
OT E: Salls and SJ)llngs can be used lnterohangeabl)' .
7. POStbon tst·reverse yoke assembly in dle shift bar
housing (inset) Install the 1st-reverse lock pin in the yoke
assembly .