Eaton FS-4205B - Page 46

REASSEMBLY - TRANSMISSION
Reassembly Countershaft and Reverse I dler (cont.)
5. Heat and lns to l11he rear oountersllatt beanng.
CAUTION Do noll1oat1he bearing above 275"F ( 136 C) .
If posstble. use a heal lamp as the sou1ce ,
6. UpreVtOusly removed, 1nstall the snapnng, oountershaft
front
bearing race { from inside of case) and lronl casa bore
plug Coat 1he outer diame1er of bore plug with loctita
#510 befo re install ing,
• •
•
7. Use grease on the two reverse ldJer thrust washers to
hold In place . Insta ll reverse idlergearwtfh tangs of wasti·
ers In housing groove . w.th the small reverse idler gear to
ttle rea r
8. tnsen 1he revtuse Idler shaft through 1he case and Idler
gQarneectie bearings lnsi.all the reverse tdlerretrunOf and
capscrew (Inset) . Make su1e Ille Idiot shall locking groove
lines t1p wrlh the capsc1ew hole. Tlgtiten 100 capsctew to
1he tacommended 1orqua .