Eaton FS-4205B - Medium- and Heavy-Duty Gen 3 - PTO Inputs and Configurations

REASSEMBLY - TRANSMISSION
Installation of Mainshaft (cont.)
29. Install the Input shatl by aligning clutching teeth on
dnve gear with tee th Jn mainshaft 5th speed synchronl2et
c up.
••
ll
30. Coal lhe outer diameter of the input shati be.anng
covar oil seal v. · ith Loc1ite #S10 . I nstall the oil seal on the
fro nt be.anng coveJ wilh a bearing driver as shown . l ns1ell
the input bearing race in the front bearing cover with the
proper beruing dflver.
54
31. Insta ll Input shafl bearing oover gaske1 , and <:ap·
sctows. The f ron t bearing cover lubricat ion oil groove m ust
beat the top . Apply LoctiteD262.tothreads ol capscsrews
and lighten 10 rooom mended torque.
NO TE: Bearing marked lor ptopec i nsta lla1fo n
32. I nst.al t the spoo®mete< d rlvo gear or rotor on the
oulpul shaft