Eaton FT1380e - Specifications; Machine Specifications; Part Numbers and Setup

ELECTRICAL REQUIREMENTS
FT1380e-115 & FT1380e-115CSA:
115-Volt AC single phase (50/60) Hz circuit with a minimum of 20 amps
FT1380e-230 & FT1380e-230CSA:
208 to 230-Volt AC single phase (50/60) Hz circuit with a minimum of 15 amps
CRIMP MACHINE DIMENSIONS
Width 16.062 inches
Depth 25.75 inches
Height 29.875 inches
Weight 258 pounds
PRODUCTION CAPACITY
Eaton braided and spiral hydraulic hoses which use TTC/Z or
4S/6S series hose ends through -20 size.
SETUP AND INSTALLATION
1. Mount your Eaton FT1380e crimp machine onto a workbench that will
support at least 300 pounds. Secure the unit using the holes provided
in the corners of the crimp machine base.
2. Remove the plug from the hydraulic reservoir vent port and replace it
with the vent cap that is supplied with the unit.
CAUTION: Failure to do so will cause cavitation and damage to the
pumping mechanism. Hand tighten the vent cap.
3. Never use an extension cord, always plug directly into the power outlet.
CAUTION: Provide electrical service with a dedicated circuit
(per the crimp machine electrical requirements) to eliminate the
possibility of a low-voltage situation.
CRIMP MACHINE PART NUMBERS:
FT1380e-115 Base machine with 115v pump
FT1380e-115CSA Base machine with 115v pump, UL/CSA approved
FT1380e-230 Base machine with 230v pump
FT1380e-230CSA Base machine with 230v pump, UL/CSA approved
CRIMP MACHINE AND TOOLING PACKAGE PART NUMBERS:
FT1380e-115-9 Contains FT1380e crimper, 115v pump,
and ET4020TP-0003 tooling package
FT1380e-115-9CSA Contains FT1380e crimper, 115v pump,
and ET4020TP-0003 tooling package, UL/CSA approved
UPGRADE PACKAGE PART NUMBERS:
FT1380e-115-UP 11 5 v Electronic Upgrade Package
(requires shipment of current machine to manufacturer)
FT1380e-230-UP 230v Electronic Upgrade Package
(requires shipment of current machine to manufacturer)
FT1380e-115-UPCSA 11 5 v Electronic Upgrade Package, UL/CSA approved
(requires shipment of current machine to manufacturer)
FT1380e-230-UPCSA 230v Electronic Upgrade Package, UL/CSA approved
(requires shipment of current machine to manufacturer)
Specications