Eaton Fuller RTLO-16610B - Line Inspection; Line Inspection and Road Test Instructions

25
Electrical Requirements
Typical DDEC V System Overview
DDEC III and IV ECM Harness Connector
Pins available for selection through engine sensor pigtail harness: W-3, X-3, and Y-3.
Note: Any two of the six pins listed may be used for “Lockout” and “Shift”. After deciding which two pins will be used, refer to the
End-of-Line Programming information based on your engine type, to complete the programming of the ECM.
DDEC V ECM Harness Connector
DDEC III and IV OEM Vehicle Interface Connector
Pins available for selection: A-1, A-2, and F-3.
ECM DDEC V
Top 2 Valve
55
40
25
16
1
10
41
45
30
56
60
15
68
61
64
26
11
65
46
31