48 INSTALLATION AND OPERATION MANUAL 25-16329-B December 2019 www.eaton.com
Section 3: Panel controls & indicators
Viewing events
To activate the touch screen, touch the top left corner of the screen until the screen
illuminates. To enter the supervisor mode touch the supervisor button and
enter the passcode.
Enter the Supervisor Mode Passcode. Select the “Others” tab and press View Log.
Use the scroll bar to view the list of upto 1000 events.
The Panel event log stores up to 1000 events including, fires, faults, resets and
address changes. Once the maximum 1000 events has been reached Panel will
automatically overwrite the oldest event every time a new event is stored.
The event log can only be reset by an approved service engineer.
Evacuate
Silence
Alarms
Mute
Buzzer
Reset
Others
Enable/Disable
Check `Config.
Print
Lamp Test
Pre
Alarms
Disabled
Faults
Weekly Test
View Log
View Fires
AC = 19
Supervisor
FRE off
Evacuate
Oldest
Silence
Alarms
Show
F
aults
Mute
Buzzer
Show
F
ires
Show
T
ests
Reset
Exit
Newest
Supervisor
FRE off
Show
A
ll
002 FIRE! Lobby, [Optical] (Ana=150)
Building 1, Ground floor, Panel 1, Loop 1, device 1
001 Monday 13-Jan-2004 08:34:12
Hard Reset
003 Monday 06-Nov- 2000 11:22.56
Soft Reset
004 Monday 13-Nov-2001, 18:09.07 Fault
Panel1, Loop 2 Zone 2, Address 5
005 Monday 18-Feb-2001 22:20.18
Mains or Battery failure
To Next Page
Loading...
