i-on40 & i-onEX Range
Page v
Compliance Statement
The i-on50EX and i-on160EX:
Are suitable for use in systems designed to comply with
PD6662:2010 at Grade 2, Grade 3 and environmental class II.
Are suitable for use in systems designed to comply with the
requirements of EN50131-3 at Grade 2, Grade3 and environmental
class II.
Comply with the requirements of EN50131-6:2008 at Grade 2, Grade
3 and environmental class II.
The i-on30EX and i-on40:
Are suitable for use in systems designed to comply with
PD6662:2010 at Grade 2, and environmental class II.
Are suitable for use in systems designed to comply with the
requirements of EN50131-3 at Grade 2 and environmental class II.
Comply with the requirements of EN50131-6:2008 at Grade 2 and
environmental class II.
When fitted with the appropriate communicator these products are
compliant with EN 50136-1. They allow the alarm transmission system to
meet the performance requirements of EN 50131-1:2006 ATS 2 provided
that:
a) They are installed in accordance with the installation instructions.
b) The connected PSTN is functioning normally.
If the installer selects a non-compliant configuration then they must
remove or adjust compliance labelling
Third party approval carried out by ANPI.
Please Note:
This Guide applies to i-on control units with version 4.04 software.
To Next Page
Loading...
Need help?
General
