Eaton IQ 100 series Quick Start Guide

www.eaton.com
IL02601010E V.1.01 Q-1
DIN Rail Installation
IQ 100 Series Transducer Quick Start Guide
Mechanical Installation
Q Installation Steps
Slide top of groove of
meter onto DIN Rail.
Press gently until the
meter clicks into place.
If mounting with DIN
Rail provided, use Black
Rubber Stoppers (also
provided) shown below.
To remove meter, pull
down on Release Clip.
Electrical Wiring Diagrams
IQ 100 Series Transducer Dimensions
WYE Direct 3 Phase, 4-wire WYE with PTs 3 Phase, 4-wire
DELTA Direct 3 Phase, 3-wire DELTA with PTs 3 Phase, 3-wire
Select a diagram to meet your
application.
NOTE: Other wiring
configurations are available.
See the IQ 100 Series User
and Installation Manual, on
the enclosed CD.
Release Clip
HIGH Side
LOW Side

Eaton IQ 100 series Specifications

General

Brand	Eaton
Model	IQ 100 series
Category	Measuring Instruments
Language	English