Eaton PRC-E Series - Page 32

28
LCD touchscreen display programming
PRC-E Series Instruction Manual MN014003EN August 2015 www.eaton.com
This will display the “Date/Time Location Configuration”
screen.
Setting the date, time, Daylight Savings Time
Date and calendar
Once in the “Date/Time Location Configuration” screen,
the “Date/Time | DST” tab is selected by default.
Tap the date entry field,
This will display the calendar screen tool.
There are multiple ways to edit the elements using
this calendar.
Scrolling through Month/Year
Tap the arrows beside the Month/Year; this will move the
month/year forward and backwards.
Selecting month
Tap the current month on the calendar,
This will display a drop down list with each month listed.
Tap the required month to choose.
Selecting the year
Tap the current year on the calendar;
This will display an edit box with up and down arrows.
Tap the up/down arrows to change the year accordingly.
Setting the date
Once the month and year are selected,
Tap the appropriate day to finish setting the date.
If any changes are made in the “Enter Date” screen, the
“Enter” button will turn “red” to signify that changes need
to be accepted.
To leave the page without accepting changes,
Tap the “Back” button.
Once all the date configuration edits are complete,
Tap the red “Enter” button to accept the changes, and
return to the “Date/Time Location Configuration Screen”.
ote:N Notice that the “Save” button in the top right corner
of the “Date/Time Location Configuration” screen did
turn red, indicating that there are some changes to
the configuration in this screen. The changes were
accepted, but not yet saved in the controller until the
red “Save” button is tapped.
Setting the time
To set an hour,
Tap the hour entry field.