Eaton SVX900 - Keypad Control Parameters (M2); STEP 5 Faults and Warning Indication; Fault Code Directory

MN04003009E
14
December 2003
STEP 4 (Continued)
Keypad Control — M2
This menu provides the parameters for the setting of the keypad frequency
reference, the selection of motor direction when in keypad operation, and
when the STOP button is active.
Table 1-1: Keypad Control Parameters — M2
Other Menus — M3 to M6
Menus M3 to M6 provide information on the Active Faults, Fault History,
System Menu settings and the Expander Board setup. These menu items are
explained in detail in Chapter 5 of the SVX9000 User Manual.
STEP 5
Faults and Fault Codes
Code/Fault Directory
Code Parameter Min. Max. Unit Default Cust ID Note
R2.1 Keypad
reference
P1.1.1 P1.1.2 Hz
P2.2 Keypad
direction
01 0 123 0 = Forward
1 = Reverse
P2.3 Stop button 0 1 1 114 0 = Stop enabled only in
keypad operation
1 = Stop button always
enabled
Fault
Code Fault
Fault
Code Fault
Fault
Code Fault
1 Overcurrent 16 Motor
overtemperature
40 Device unknown
2 Overvoltage 17 Motor underload 41 IGBT temperature
3 Ground (Earth)
Fault
22 EEPROM
checksum fault
42 Brake resistor
overtemperature
5 Charging Switch 24 Counter fault 43 Encoder fault
6 Emergency stop 25 Microprocessor
watchdog fault
44 Device change
(different type)
7 Saturation trip 26 Startup prevented 45 Device added
(different type)
8 System fault 29 Thermistor fault 50 Analog input I
in
< 4 mA (for the
signal range 4 to
20 mA)
9 Undervoltage 31 IGBT temperature
(hardware)
51 External fault
10 Input line
supervision
32 Fan heat sink 52 Keypad
communication
fault
11 Output phase
supervision
34 CAN bus
communication
53 Communication
bus fault
12 Brake chopper
supervision
36 Control unit 54 Slot fault
13 SVX9000
undertemperature
37 Device change
(same type)
56 PT100 board
temperature fault
14 SVX9000
overtemperature
38 Device added
(same type)
— —
15 Motor stalled 39 Device removed — —
MN04003009E.fm Page 14 Thursday, February 17, 2005 11:59 AM