Eaton XN300 - 34.1 Status LEDs

34 DC motor driver module XN-322-1DCD-B35
34.1 Status LEDs
265 XN300 slice modules 02/24 MN050002EN Eaton.com
34.1 Status LEDs
Figure 140: XN-322-1DCD-B35 LEDs
a Module status LED
b User status LED
c Motor power supply status LED
d Motor status LED
e Module power supply status LED
Module status
Green ON System OK
OFF No power
FLASHES (5 Hz) No communications
Status User
yellow ON The user can set the LED signals as necessary.
(For example, the visualization interface can be
used to set the module's LED to flash so that it is
easier to find the module inside the control panel.)
OFF
FLASH
(200 ms ON,
1000 ms OFF)
FLASH
(1000 ms ON,
200 ms OFF)
Motor power supply
status
red ON Faulty motor power supply
OFF Motor power supply OK
Motor Status Green ON Motor enable signal active
OFF Motor enable signal not active
Module power supply
status
red ON Faulty module power supply
OFF Module power supply OK
S
U
③
①
④
⑤
②
X1
V+
0V
M+
M-
X2
1+
1-
2+
2-
X3
24
24
0V
0V
1DCD
B35