Eaton XN300 - 13.1 Status LEDs; 13.5 Connection terminals

13 Relay output module XN-322-4DO-RNO
13.1 Status LEDs
XN300 slice modules 02/24 MN050002EN Eaton.com 78
13.1 Status LEDs
Figure 46: LED signals and pin assignment
a Module status LED
b User LED
c Output 1 status LED
d Output 2 status LED
e Output 3 status LED
f Output 4 status LED
Module status
Green ON System OK
OFF No power
FLASHES (5 Hz) No communications
User
yellow ON The user can set the LED signals as necessary.
(For example, the visualization interface can be used to set
the module's LED to flash so that it is easier to find the
module inside the control panel.)
OFF
FLASH
(200 ms ON,
1000 ms OFF)
FLASH
(1000 ms ON,
200 ms OFF)
Output status yellow ON Relay contact closed
OFF Relay contact open
S
U
4D0
RN0
X2
C2
R2
R2
X3
C3
R3
R3
X1
C1
R1
R1
X4
C4
R4
R4
③
①
④
⑤
⑥
②