HOW TO OPERATE YOUR PRECISON TRACKER
Before First Use
1. Inserting Batteries and Selecting Measurement Unit
a) Open the battery compartment door on the back of the scale.
b) Put the batteries in, flat end (negative terminal) against the spring. The LCD will
display.
c) Close the battery door and wait until is shown on the
LCD.
d) Press “UNIT” button (located underneath scale) to select the desired
measurement unit; pounds or kilograms. The default is set to lbs.
2. Calibration
a)
Place the scale on a hard, flat surface.
If the scale is turned on when placed
down on the floor, allow the scale to turn off without standing on it. If the
scale does not turn on when placed down, press the glass platform with
one foot to turn the scale on. Step off. Allow the scale weight to go to 0.0
and turn off without standing on it.
Note: Avoid carpet or other soft flooring like Pergo™ or types of linoleum
Your Precision Tracker operates via “Step-On” technology but still needs to be calibrated
upon first use or after the scale is moved to ensure accuracy.
Note: When you pick up the scale, move the scale or replace batteries, the scale may lose
calibration. You can either calibrate (see above) or disregard the first weight after the scale is
moved. If the scale is not calibrated it will add 4.2 lbs to your weight and that represents the
weight of the glass platform.
If you step on and off the scale repeatedly you should obtain the same weight. Uneven
flooring or softness in flooring may cause weight fluctuation. Move the scale to a different
surface and re-calibrate or call support at 201 465 4381 9-5 EST.
To Next Page
