KF760 Series Rigging Procedures PRELIMINARY DRAFT -- 21 Aug 01
KF760 Series Rigging Procedures PRELIMINARY DRAFT -- 21 Aug 01 Page 9 of 29
5. Disconnect pallet from the front of the bottom enclosure by removing the four short connecting pins.
Insert the four connecting pins in the bottom enclosure Hinge Tubes.
6. Bring in flown enclosures to within about 1in / 25 cm of the front top of palleted enclosures.
7. Slide up the two front hinges of the topmost palleted enclosure into bottommost flown enclosure and
temporarily pin the hinge to the topmost palleted enclosure s Hinge Tubes.
NOTE: This aligns the KF760 with the flown enclosure above it for the next step.
To Next Page
Loading...
