KF760 Series Rigging Procedures PRELIMINARY DRAFT -- 21 Aug 01
KF760 Series Rigging Procedures PRELIMINARY DRAFT -- 21 Aug 01 Page 10 of 29
8. Land the flown enclosures on the palleted enclosures so the enclosure fronts just touch.
9. Remove the two short connecting pins temporarily inserted into the front hinges. Engage the two front
hinges in their fully extended position into the Hinge Tubes of the flown enclosure and secure using a
short connecting pin in each.
10. Land the flown enclosures on the palleted enclosures so the weight is off the chain motors.
NOTE: It may be advantageous to push the palleted KF760s forward as they mate with the flown
enclosures. This will help prevent the front of the flown enclosures from pivoting on the front of the
palleted enclosures and tipping forward.
To Next Page
Loading...
