EasyManua.ls Logo

EB Excalibur Sky Runner - Troubleshooting

EB Excalibur Sky Runner
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
Safety Tips:
• Read through the entire instruction manual, before attempting to pilot your
helicopter.
This product is intended for indoor use, and works best indoors. We do not
recommend using the product outdoors.
• Never attempt to  y your helicopter in a cluttered space. This helicopter was
intended for obstacle free wide area spaces.
• Make sure all people and animals are 3-5 feet from the helicopter before you
start  ying it.
• Always keep focus on your helicopter, and do not attempt to  y/land/or
crash anywhere on or near any other people or animals.
The rotating parts on the helicopter could lead to injury. Never put any body
part including the hands and face, close to the rotating parts. Only
operate this product standing, as it allows for quick movement away from
the helicopter if necessary.
• Never operate the helicopter using parts that are altered in shape or
damaged in any form.
Troubleshooting:
Problem Cause Correction
Helicopter is not
responding to remote
Loss of Control
Helicopter Spinning out
of control
Helicopter suddenly stops
and drops mid ight or
seems to have weak
performance
Propellers are not moving
Channel selection on the
remote.
Interference of another
remote controlled device
Interference by other
conditions such as
lighting.
Incorrect trim
adjustment.
Weak battery power.
Helicopter is powered o .
Weak battery power.
Gently press forward on the left joystick and
switch between all 3 channels until the helicopter
takes  ight.
Avoid all other remote controlled devices running
on the same channel.
Change environment to better suited conditions.
Adjust the trim as shown above to  nd the proper
adjustment.
Recharge the helicopter battery. If this does not
work, replace the batteries in the remote and
recharge o fresh batteries.
Set the ON/OFF Switch to the ON position.
Recharge the helicopter battery. If this does not
work, replace the batteries in the remote and
recharge o fresh batteries.
US9969IS01EXC.indd 6US9969IS01EXC.indd 6 7/29/11 11:32 AM7/29/11 11:32 AM

Related product manuals