Ebac 2000 Series Manual&Nbsp;

8
9
Power indicator light is illuminated, but the unit is not collecting water.
Check
1. The humidistat (if activated) may be set too low, increase the setting.
2. The water container may be full, empty the container.
3. The unit may have been set to standby mode – check the settings.
4. Ensure the water container is fitted. If you continue to have problems please see ‘Requesting Service’.
Fan operates continuously.
Check
1. Check that the continuous fan operation is not selected. If you continue to have problems please see ‘Requesting
Service’.
Reduced water extraction.
Check
1. The humidistat (if activated) may be set too low, if signs of condensation or dampness remain, increase the
setting.
2. The filter may be blocked. Remove, clean and refit.
3. After being installed all dehumidifiers will collect less moisture as initial excess moisture is removed. This is
normal.
4. The dehumidifier may be positioned next to a heat source i.e. a radiator – reposition. If you continue to have
problems see ‘Requesting Service’.
Dehumidifier collects water but is not preventing condensation.
Check
1. The humidistat (if activated) may be set too low, increase the setting.
2. Increase the fan speed to NORMAL if set to QUIET.
3. Outside temperatures have dropped suddenly. The dehumidifier may take a few days to get the problem back
under control.
If you continue to have problems please see ‘Requesting Service’.
Your Ebac 2000 Smart Control will collect excess moisture either as condensed water or ice on the evaporator coil
located behind the filter.Any accumulation of ice is cleared periodically automatically.
This maximises the efficiency of the unit at temperatures between 3˚C (37˚F) and 25˚C (77˚F).Above 25˚C no defrost is
required.
The Ebac 2000 Smart Control series can be used in unattended dwellings such as holiday homes, without emptying
the water container. To use this facility you must order a permanent drainage kit. To order, please see the order form
enclosed with this manual or contact your retailer.
Your Ebac 2000 Smart Control has a full range of optional accessories available to ensure that you get the most out of
your dehumidifier. These include high performance filters and castors. Please see the brochure included with your
dehumidifier for further details.
Always check the following list before requesting service. Should a service call be requested and the fault be found to
be detailed below, a charge may be made.
Power indicator light is not illuminated.
Check
1. The unit is switched on at the mains. If necessary test the socket by plugging in another appliance.
2. Check the fuse in the plug and if necessary replace with another fuse, (13 amp for 2650e and 2850e models. If
you continue to have problems please see ‘Requesting Service’.
Automatic defrost system
Using the permanent draining facility
Optional accessories
If your Ebac 2000 fails to operate
If your Ebac 2000 fails to operate

Ebac 2000 Series Specifications

General

Brand	Ebac
Model	2000 Series
Category	Dehumidifier
Language	English