Getting the most from your Powerdri
1. Ensure internal doors are kept ajar where possible to allow air circulation.
2. Ensure external doors and windows are kept closed as much as possible
3. Ensure the unit is positioned on a flat, even surface.
Setting the controls
Humidistat
Turn the humidistat to the appropriate symbol on the dial. When drying is complete switch off the
dryer by turning the Humidistat to its lowest setting and unplugging the dryer from the mains. When
using for automatic humidity control initially turn to the highest setting, when signs of excess
moisture are reduced, gradually turn the humidistat dial anti-clockwise to the point where the dryer
just switches off. This level of humidity will now be maintained.
If signs of excess moisture re-appear, increase the humidistat setting slightly until the problems
are again under control.
Fan speed control
Setting
1
2
Function
Low/Quiet Setting
Hi
gh Setting for maximum extraction
To adjust the fan speed, turn the fan speed dial to the desired position.
Emptying the water container
The red light on the control panel will illuminate when the container if full. When this occurs, water
collection stops.
To empty, open the water
container access door
The container can then be removed
and emptied as shown
Replace the container back into the
dehumidifier with the outlet on the
left hand side and gently close the
door.
Setting
Mid humidistat setting for homes with general moisture levels
Control unwanted moisture wherever it occurs
Assists with indoor laundry drying
Dry rooms and plaster quickly and effectively
High humidistat setting for maximum extraction
To Next Page
Loading...
Need help?
General
