EasyManua.ls Logo

Ebac Powerdri - Filter Maintenance and Cleaning; Installing the Drainage Kit

Ebac Powerdri
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Cleaning the filter
Your Powerdri has a filter to remove dust from the air.
This filter should be cleaned every month and replaced every 3 to 4 months dependent upon usage.
Failure to do this will reduce the performance of your dehumidifier and may, over time lead to a
permanent reduction in performance.
Remove the filter cartridge from
the rear of the unit.
Clean the filter using a vacuum
cleaner on a low power.
Replace the filter cartridge onto the
rear panel.
Using the Permanent Drainage Facility
Your dryer can be used in unattended dwellings such as holiday homes without emptying the water
container. To enable this facility you must use the permanent drainage kit supplied.
Fitting the Drainage Kit
Disconnect the Powerdri from the power supply before fitting the drainage kit.
Remove the permanent drainage seal from the rear of the unit.
To prevent this being mislaid this is attached to the rear of the panel of
your dryer.
Locate the end of the drainage tube with the bleed hole.
Push this end of the tube onto the permanent drainage outlet (it may help
to dip the end of the tube in hot water for a few seconds to soften it)
ensuring that the bleed hole is located at the top.
Ensure that the tube is securely attached to the drainage outlet and route
the pipe ensuring that:
The pipe is not kinked nor has an excessive number of bends in
it.
The level of the pipe does not rise above the level of the
machine's drainage outlet.

Related product manuals