EBARA E-SPD MT 2200 - Page 19

19
EN
EN
Par. Descripción Ud.
Programación
Defecto Min. Max.
Notas
OFF
OFF
M-Su
M-F
Sa-Su
M ….. Su
5.16 SCHEDULE PROGRAM 1
In this parameter you can choose not to have a
schedule program (OFF) or the days of the week that
you want this program to run. You can choose between
whole weeks (M-Su), weekdays (M-F), weekends (Sa-
Su) or individual days.
The schedule program will act on the output relay
programmed for this purpose.
00:00 00:00 23:595.17 PROGRAM START TIME 1 Start time of schedule program 1.
00:00 00:00 23:595.18 PROGRAM STOP TIME 1 Stop time of schedule program 1.
00:00 00:00 23:595.20 PROGRAM START TIME 2 Start time of schedule program 2.
00:00 00:00 23:595.21 PROGRAM STOP TIME 2 Stop time of schedule program 2.
YES YES NO
5.22
LOW WATER LEVEL ALARM
ACTIVE
Parameter for enabling or disabling the low water
level alarm.
In the case of being active and cause notice, the
drive will start attempts by the following sequence:
5 minutes, 15 minutes, 1 hour, 6 hours or 24 hours.
The display shows the remaining time start attempt.
Pressing F2 we force the reset of the notice, still
unfinished countdown.
If after the 24-hour notice is detected again dry
running, the drive will lock indefinitely until you
press F2.
51995.23
LOW WATER LEVEL ALARM
DELAY
Sec
Time from when the system calculates a low water level
until the moment the alarm is activated for this reason.
YES YES NO5.24 BURST PIPE ALARM
Parameter for enabling or disabling the burst pipe
alarm.
YES YES NO5.25 VOLTAGE ALARM ACTIVE
Parameter for enabling or disabling the alarm due to
a power cut.
NO NO YES5.26 PARAMETER LOCK
YES: Editing the values of the parameters is locked.
NO: Editing the values of the parameters is locked.
To change this parameter from YES to NO, you must
previously enter the password 1357.
NO NO YES5.27 SET DATE AND TIME
When you change this parameters to “SI” this screen for
editing the date and time will appear. Once editing is
completed, the parameter returns to “NO”.
NO NO YES5.28
STOP FREQUENCY SEARCH
WIZARD
If you change this parameter from “NO” to “YES” the
stop frequency search wizard will be launched.
NO NO YES5.29 FACTORY SETTINGS
To reset the unit and leave it with the factory settings,
change this parameter to “YES” and after you have entered
the code 1357 the unit will launch the start-up wizard.
OFF5.19 SCHEDULE PROGRAM 2 Like parameter 5.16 but for a second schedule program.
OFF
M-Su
M-F
Sa-Su
M ….. Su