- 10 -
Programming stations
You can program ten stations using the
buttons
MEM 1/6
k
, MEM. 2/7
l
, MEM. 3/8
;
,
MEM. 4/9
g
, MEM. 5/10
f
.
1 Press the POWER
h
button.
2 Find a station as described in the sec-
tion "Station search function".
3 Press the button MEM.SET
d
."MEM"
flashes on the display.
4 Press the button with the desired
memory location:
MEM 1/6
k
, MEM. 2/7
l
,
MEM. 3/8
;
, MEM. 4/9
g
,
MEM. 5/10
f
.
➪ Press the memory button once for
the first memory location. Press the
memory button twice for the second
memory location.
5 Press the button MEM.SET
d
again.
The station is programmed.
➪ To adjust programmed stations press
the corresponding memory button
(MEM. 1/6
k
to MEM. 5/10
f
) once or
twice in radio mode.
AMS (Automatic Memory System)
By means of the AMS function, the radio
automatically searches for stations with
an RDS signal in storage locations
MEM.1/6
k
to MEM. 5/10
f
.
➪ Switch on the radio using the button
POWER
h
.
➪ Keep the button Mem. Review/AMS
o
pressed for two seconds. The kit-
chen radio automatically searches for
the next station and stores it.
➪ The station search function can be
stopped by pressing the button
AL1/VOL+
r
or AL2/VOL-
u
.
If you wish to start the AMS function
from a certain frequency, adjust the start
frequency by pressing Up
e
or Down
i
.
➪ Keep the button Mem.Review/AMS
o
pressed for two seconds.The kit-
chen radio now automatically sear-
ches for the next station, beginning at
the starting frequency, and stores it.
If you wish to call up stored stations,
press the button Mem.Review/AMS
o
during radio operation. The kitchen radio
plays each station for five seconds.
➪ Press the button POWER
h
or a me-
mory button (MEM 1/6
k
,
MEM. 2/7
l
, MEM. 3/8
;
,
MEM. 4/9
g
, MEM. 5/10
f
), to stop
this function.
Adjusting the volume
➪ Press the button VOL +
r
during ra-
dio operation to increase the volume.
➪ Press the button VOL -
u
to reduce
the volume.
Lock function
You can lock the kitchen radio so that
settings canot be altered by unauthori-
sed people or children.
➪ Keep the button MEM.SET
d
pressed.
A key symbol appears on the display.
➪ To disable the lock function, keep the
button MEM.SET
d
pressed again
until the key symbol goes out.
KH2288
To Next Page
Loading...