Eberg ELIO E35T1 - R290 Refrigerant Gas Safety Information; Handling and Storage Precautions for R290

ELIOEN
31
www.eberg.eu
supervision of the person competent in the use of ammable refrigerants.
22. Do not operate or stop the unit by inserting or pulling out Die power plug, it may cause electric
shock or re due to heat generation.
23. Unplug the unit if strange sounds, smell, or smoke comes from it.
Notes:
- If any parts damage, please contact the dealer or a designated repair shop;
- In case of any damage, please turn o the air switch, disconnect the power supply, and contact the
dealer or a designated repair shop;
- In any case, the power cord shall be rmly grounded;
- To avoid the possibility of danger, if power cord is damaged, please turn o the air switch and disconnect
the power supply. It must be replaced from the dealer or a designated repair shop.
If the appliance have the Wi-Fi function , the transmission power: less than 20dBm, and the radio frequency
range is: 2412MHz-2472MHz.
Warning
Do not use means to accelerate the defrosting process or to clean, other than those recommended by
the manufacturer. The appliance shall be stored in a room without continuously operating ignition
sources (for example: open ames, an operating gas appliance or an operating electric heater. Do not
pierce or burn.
Be aware the refrigerants may not contain an odour. Appliance shall be installed, operated and stored
in a room with a oor area larger than X m2.
Quantity of R290 gas in charge (see rating label on
the appliance) (g)
Minimum size of the site for use and
storage (m²)
m<152
4
152≤m≤185
9
186≤m≤225
11
226≤m≤270
13
271≤m≤290
14
291≤m≤300
15
Specic information regarding appliances with R290 refrigerant gas.
• This appliance contains Y g (see rating label back of unit) of R290 refrigerant gas.
• R290 is a refrigerant gas that complies with the European directives on the environment.
• Do not puncture any part of the refrigerant circuit.
• If the appliance is installed, operated or stored in an unventilated area, the room must be designed
to prevent to the accumulation of refrigerant leaks resulting in a risk of re or explosion due to
ignition of the refrigerant caused by electric heaters, stoves, or other sources of ignition.
• The appliance must be stored in such a way as to prevent mechanical failure.
• Individuals who operate or work on the refrigerant circuit must have the appropriate certication
issued by an accredited organization that ensures competence in handling refrigerants according to
a specic evaluation recognized by associations in the industry.
• Repairs must be performed based on the recommendation from the manufacturing company.
Maintenance and repairs that require the assistance of other qualied personnel must be performed
under the supervision of an individual specied in the use of ammable refrigerants. Ducts
connected to an appliance shall not contain a potential ignition source.