Eberg ELIO E35T1 - Troubleshooting Common Appliance Problems; Addressing Power Issues and Cooling Performance Problems

ELIOEN
55
www.eberg.eu
Run o all water left into abasin. When all the water has been drained, put the cap back in place.
Clean the lter and dry thoroughly before putting back.
STRICTEST OPERATION ENVIRONMENT:
Cooling mode: 18°C-35°C (64°F-95°F, 30%RH~90%RH
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The appliance
does not come on
• There is no current
• It is not plugged into the
mains
• The internal safety device
has tripped
• Wait
• Plug into the mains
• Wait 30 minutes, if the problem
persists, contact your service center
The appliance
works for ashort time only
• Here are bends in the air
exhaust hose
• Something is preventing
the air from being
discharged
• Position the air exhaust hose
correctly, keeping it as short and
free of curves as possible to avoid
bottlenecks
• Check and remove any obstacles
obstructing air discharge
The appliance
works, but does not
cool the room
• Windows, doors and/or
curtains open
• Close doors, windows and curtains,
bearing in mind the "tips for correct
use" given above
• There are heat sources in
the room (oven, hairdryer,
etc)
• Eliminate the heat sources
• The air exhaust hose
is detached from the
appliance
• Fit the air exhaust hose in the
housing at the back of the appliance
• The technical specication
of the appliance is not
adequate for the room in
which it is located