ECA MCI-3000V4 User Manual

5
U
U
U
N
Example ( II ) 0 0 1 => the Name Number of the unit.
2 => the second phone number for this unit.
*55521311* => the phone number entered is: 5521311
9 => the system will wait 9 ring tones before hanging up and dialing the 3
rd
phone number.
# => command to save the programming.
The system will confirm the programming by announcing:
“ The number is: five five five two one three one one ”
Example ( III ) 0 0 1 => the Name Number of the unit.
3 => the 3
rd
phone number for house No. 1
* # => no number is stored as a 3
rd
phone number and the phone number is
DELETED from this memory location.The system will confirm this
command by announcing: “The phone number was deleted”.
ADDING (programming) USER’S PHONE NUMBERS BY SMS COMMAND
You can also send SMS COMAND to add or change user’s phone number by a special format of SMS message as
follows:
- The first four letters represent the Password ( P P P P ).The factory default Password is 9 9 9 9
- Followed by the letter “ A ” that represent A dding (or changing) the user’s phone number.
- ( U U U ) represent the unit’s name number, from 001 to 999
- Then (N N N …. N N N) represent the phone number followed by the “ * ” star symbol
- Then (N) represent the 1
st
or the 2
nd
or the 3
rd
phone number for the unit followed by the star symbol “ * ”
- ( R ) represent the number of Rings (from 1 to 9 rings) that the unit will wait for an answer, before it will
hang up and dial the next phone number in the memory.
2. Deleting users’ phone numbers in the system.
You can reprogram a new phone number to be instead of an old one, by simply reprogramming a new number for the
same memory location. The system will automatically delete the old number and replace it with the new user’s phone
number that you have entered. You can DELETE the user’s phone numbers in the system in two ways;
via the keypad or by SMS command.
 Deleting the users’ phone numbers via the keypad.
1.Enter program mode.
2.Use the following format to delete a user’s phone number:
The letters (U U U) represent the unit’s Name Number, from 001 to 999 followed by star and hash symbols.
The letter (N) represents the 1
st
or the 2
nd
or the 3
rd
phone number of the unit.
The following is an example of how to delete the 3
rd
phone member of unit 901;
In program mode press: 9013 * #
9013 => The Name Number (901) followed by the number 3 to indicate 3
rd
phone number of the unit
* # => end of command. (Memory position 3 is cleared).
The system will confirm this command by announcing: “The phone number was deleted”.
Example
:
SMS message programming
the
first
user’s
phone number
for unit name number 901 which is 0
395720535
9999A9011*0395720535*5#
=> Please Note: The system is sensitive to cases and space between the letters.
U
U
U
N
N
N
N
N
N
. ..
P
P
P
P
A
R
N

ECA MCI-3000V4 Specifications

General

Brand	ECA
Model	MCI-3000V4
Category	Intercom System
Language	English