P/N A51-4473-16 Page 14 Rev 4.3.3
10) On the M.O.L.E. menu, click the Select Instrument command.
11) Select the MEGARIDER™ PTP® instrument from the dialog box.
If the software does not detect a M.O.L.E. Profiler, using the communication cable
connect it to the computer and click the Scan for Instruments command button to
search again. M.O.L.E.® MAP software allows multiple instruments to be connected
to a computer at one time. Selecting the Scan for Instruments command button will
detect all instruments and display them in the dialog box. If no instrument is
detected the software displays all of the Demonstration thermal profilers to select
from.
12) Click the OK command button to accept or Cancel to quit the command without selecting the
instrument.
13) Turn the PTP® TX power by removing the On/Off Male Plug connector from the Female
On/Off Power connector.
To Next Page
Loading...