ECD MiniM.O.L.E. - Setup; Communications Setup

P/N A51-4473-16 Page 7 Rev 4.3.3
Setup
Communications Setup
Prior to operation the M.O.L.E. Profiler must be configured to properly communicate with the
M.O.L.E.® MAP Software.
The M.O.L.E.® MAP software must be installed prior to communications setup.
(Refer to Software Installation for more information).
To connect the M.O.L.E. Profiler:
1) Insert the USB computer interface cable from the Dock Station into a computer USB Port.