GB
24
2. Let the appliance run for 2 hours in the air ow mode until the inside is all dried up.
3. Turn o the appliance and unplug it.
4. Clean the lter and replace it.
5. Remove the exhaust hose assembly and store it carefully.
6. Remove the batteries from the remote control.
7. Put the appliance in aplastic bag and store it in acool and dry place.
Do the following after long term storage of the appliance before using it again:
1. Make sure that the lter and the drain plug are in place.
2. Check the power cord for any damage. When it is damaged, do not use the appliance.
3. Insert batteries in the remote control.
4. Reinstall all accessories in accordance with installation instructions.
Common defects and their diagnosis
Intelligent detection of defects
Error code Diagnosis
E1 Temperature sensor coil defect.
E2 Defect of room temperature sensor
E4 Freeze protection: when the temperature of the spiral falls below 0° C, the appliance
stops. When the temperature of the spiral rises above 8 °C the protection is deactivated
and normal functions resume.
Troubleshooting
Problem Possible cause Solution
Air conditioner does
not work.
No power Switch on power.
Display shows “FL”. Switch o , drain water, switch on
again.
The shut o function by timer is
activated.
You can turn the air conditioner back
on 3 minutes after turning o .
Insu cient cooling
performance of the air
conditioner.
Direct sunlight Close the curtains.
Open doors and windows, or too many
people or heat sources in the room.
Close the doors and windows and
eliminate the heat sources.
Clogged lter Clean or replace the lter.
Blocked air intake or exhaust. Remove the blockage.
The air conditioner is
too noisy.
The appliance is not level. Place it on alevel and rm surface and
try to prevent vibrations.
The compressor does
not work.
The heat protection of the compressor
was activated.
Wait 3 minutes and after cooling o
start again.
MK 103_manual_cz_sk_gb_hr.indb 24 1.2.2016 12:09:31
To Next Page
Loading...
