ECG MS 005 O - Clock Setting

24

EN

25
Reception state
After successful signal reception icon lights up (stops ashing).
At signal reception failure
icon disappears.
Automatic and manual reception
Automatic reception: clock attempts automatic reception any time at 01:00. If reception at 01:00 fails it
continues at 03:00. If reception at 03:00 fails it continues at 05:00.
If no successful signal reception is done even at 05:00 it continues every 3 hours till correct DCF signal is
received.
Manual reception: To run DCF signal reception manually, press WAVE button. Time LED display turns to
reception mode .
Clock setting
To set hour, hold TIME button and concurrently press HOUR button.
To set minutes, hold TIME button and concurrently press MINUTE button.
Alarm 1 setup
To set hour, hold ALM 1 button and concurrently press HOUR button.
To set minutes, hold ALM 1 button and concurrently press HOUR button.
Alarm 2 setup
To set hour, hold ALM 2 button and concurrently press HOUR button.
To set alarm minutes, hold ALM 2 button and concurrently press MINUTE button.
Alarms 1 and 2 turn on and o
After alarm 1 turn on, press ALM button; ALM 1 LED lights up in clock´s left upper corner.
After alarm 2 turn on, press ALM button again; ALM 2 LED lights up in clock´s left lower corner.
To turn on both alarms 1 and 2, press ALM button again; ALM 1 and ALM 2 LEDs light up.
To turn o both alarms 1 and 2, press ALM button again; ALM 1 and ALM 2 LEDs switch o.
Snooze function use
While time set on alarm 1 or alarm 2 comes on, clock begins to sound and ALM 1 or ALM 2 LEDs ash. To turn
o sound, press SNOOZE button; ALM 1 or ALM 2 LEDs still ash. Alarm clock begins to sound after 5 minutes.
Alarm turn o
While time set on alarm 1 or alarm 2 comes on, clock begins to sound and ALM 1 or ALM 2 LEDs ash. To turn
o alarm, press ALM 1 or ALM 2 button; ALM 1 or ALM 2 LEDs still light.
Alarm 1 or 2 will be active next day again.
Snooze time setup (between 5 and 60 minutes)
By holding SNOOZE button, clock shows “05” (default snooze value); then set the desired time.
Indoor maximum and minimum temperatures display
To show recorded maximum indoor and outdoor temperatures, press MAX/MIN button. To reset record,
hold MAX/MIN button. Maximum value is shown as “--” for now and new recording begins.
To show recorded minimum indoor and outdoor temperatures, press MAX/MIN button again. To reset
record, hold MAX/MIN button. Minimum value is shown as “--” for now and new recording begins.