Need help?Do you have a question about the Echelon i.LON SmartServer and is the answer not in the manual?
Outlines the general steps for assembling and connecting the device.
Details how to physically mount the SmartServer unit.
Details how to connect wires to the device's screw terminals.
Details the power connection requirements and safety.
Instructions for connecting to LONWORKS networks.
Details connections for RS-232 and RS-485 serial ports.
Instructions for connecting a GSM modem via the RS-232 port.
Instructions for connecting M-Bus devices via RS-232.
Instructions for connecting Modbus devices via RS-232/RS-485.
Details how to connect and use the device's digital outputs.
Details how to connect and use the pulse meter inputs.
Details how to connect and use the digital inputs.
Details the +12V < 20mA output connection and usage.
Instructions for connecting the device to an Ethernet network.
Instructions for connecting to the device's console port.
Instructions for connecting the telephone line port for modem use.
Steps and considerations for powering on the SmartServer.
Describes the function and status indication of the SmartServer LEDs.
Explains the function and usage of the service pin and reset switch.
General| Model | i.LON SmartServer |
|---|---|
| Category | Network Hardware |
| Flash Memory | 32 MB |
| Operating System | Embedded Linux |
| Ethernet | 10/100 Mbps |
| Ethernet Ports | 1 |
| Connectivity | Ethernet, Serial, USB |
| Protocols Supported | LonWorks, IP |
| Memory | 64 MB RAM |
| USB Ports | 1 (USB 2.0) |
| Operating Temperature | -40°C to 70°C |
| Power Supply | 24 V AC/DC or 100–240 V AC (depending on model) |
| LonWorks Interfaces | FTT-10, TP-1250 |
To Next Page