Echelon STRIDE-s - Bluetooth App Connectivity; Connecting to the Echelon App; Error Codes and Troubleshooting (Part 1); Troubleshooting Error Codes (E01-E04)

22
|
CONSOLE OPERATION
CONSOLE OPERATION (cont’d.)
ERROR CODE PROBLEMS SOLUTIONS
E01
Connection fails
between “PCB” and
“Lower Control Board”
1. Check every wire is connected well between PCB and lower control board.
2. Check if any of the wire is damaged.
3. Check if PCB or lower control board is in good condition. If any chip is damaged, change PCB or lower control board.
E02
Over-loading
Protection
1. Check if power outlet has low voltage supply. If so, change a power outlet.
2. Check if lower control board has bad smell. If so, change a lower control board.
3. Check if wires connected to motor are well connected.
E03
No signal from speed
sensor
1. Check if wire of speed sensor is well connected.
2. Check if wire or speed sensor is damaged. If so, replace wire and speed sensor.
E04 Incline motor damage
Perform incline calibration
3. Remove Safety Key
4. Press and hold “Start” & “Stop” buttons for over 3 seconds.
5. After the incline calibration is completed, test the treadmill again by powering on and press “Start” button.
BLUETOOTH APP
To connect the Echelon app and begin live session, search and download “Echelon Fit.”
Follow the instructions on the app for the Bluetooth setting and the registration.
ERROR CODES AND TROUBLESHOOTING