GB-1
Introduction to the Operating Instructions
These Operating Instructions are intended to facilitate your becoming acquainted with the machine and using it in
accordance with the regulations. The Operating Instructions contain important information on how to use the machine
safely, correctly and economically. Observing this information will help increase the reliability and working life of the
machine. The Operating Instructions must always be at hand when the machine is being used.
They must be read and observed by every person dealing with the machine, whether operating, servicing or trans-
porting it.
In addition to the Operating Instructions and the applicable rules of the prevention of accidents valid in the country
of use and on site, the generally recognised rules on working safely and correctly must be observed as well as the
accident prevention rules of the relevant professional associations.
ENGLISH
Technical Data
The devices are manufactured in accordance with the provisions of DIN EN 60745-2-13 and fully comply with the
provisions of the German Product Safety Act.
Model KSE 2400 (CS 1800) 2400 (CS 2400)
Rated Voltage V~ 230 230
Nominal Frequency Hz 50 50
Fuse (time lag) A 16 16
Rated Output W 2400 2400
Nominal current A 11,1 11,1
Guide Bar mm 350 400
Cutting length mm 340 380
Speed m/sec ca. 12 ca. 12
Weight kg 4,3 4,4
Oil ml 200 200
All models with automatic chain lubrication and mechanical chain brake and rundown brake.
The type designation of the chain you will nd on the type plate.
Class of Protection: II/ DIN-EN 60745-1
Interference Suppression: according to EN-55014
Noise emission information in accordance with the German Product Safety Act (ProdSG) and the EC Machine Direc-
tive
Noise emission values EN-60745-2-13: Sound Pressure Level L
pA
90 dB (A) [K=3,0 dB (A)]
Vibration values in accordance with EN 60745-2-13: Weighted acceleration handle max. 6,0 m/s
2
[K=1,5 m/s
2
]
Attention: This chain saw is only intended for cutting wood !
General safety instructions
Noise emission information in accordance with the Ger-
man Product Safety Act (ProdSG) and the EC Machine
Directive: the noise pressure level at the place of work
can exceed 80 dB(A). In such cases the operator will
require noise protection (e.g. wearing of ear protectors).
Attention: Noise protection! Please observe the lo-
cal regulations when operating your device.
General safety information for power tools
WARNING: Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, re and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
Electric Chainsaw
Translation of the original Operating Instructions
To Next Page
Loading...
Need help?
General
