OPERATION CS-2511P
34 X7503333700
© 11/2020 ECHO Incorporated
1. Move chain brake lever (A) fully
FORWARD to LOCK chain
brake before starting.
2. Confirm there is fuel and chain
oil in the tanks.
3. Move STOP switch (B) to RUN
position.
4. Securely hold the chain saw as
shown and pull starter handle
(E).
5. Choke can be used if
necessary, but after first starting
sound, squeeze throttle trigger
lock (G) and throttle trigger (F)
to release choke and return
engine to idle.
Note: If engine does not start
after 5 pulls, use “Start
Cold Engine” procedure.
To Next Page
Loading...
