Echo CS-271T Operator's Manual

31
CS-271T
WARNING
Do not store in an enclosure where fuel
fumes may accumlate or reach an open flame
or spark.
CAUTION
Do not lend or rent your chain saw without
the Operator's Manual and Safety Manual.
NOTICE
•Forfuturereference,youshouldkeepthis
Operator's Manual and the Safety Manual.
•IfthisOperator'ManualortheSafetyManual
has become illegible or is lost, please purchase
a new one from your ECHO dealer.
STORAGE AFTER USE
• Inspectandadjusteverypartofthechainsaw.
- Completely clean every part and repair if
necessary.
- Apply thin coating of oil on metal parts to
prevent rust.
• Removechainandguidebar.
• Drainfueltank,pullstarterslowlyafewtimesto
drain fuel from carburetor.
• Pourasmallamountofcleanmotoroilintospark
plug hole, pull starter and crank the engine until
piston reaches: TOP DEAD CENTER.
• Storeinadryarea,freefromdust.

Echo CS-271T Specifications

General

Engine Displacement	26.9 cc
Bar Length	12 inches
Chain Pitch	3/8 inch
Fuel Capacity	0.21 L
Chain Oil Type	Bar and chain oil
Chain Gauge	0.050 inch
Oil Capacity	160 ml