CS-3410 OPERATION
X7503361801 33
© 10/23 ECHO Incorporated
8. Pull starter handle to start the
engine.
Note: Do not pull starter rope out to
the maximum possible
position.
Note: Do not allow recoil handle to
snap back against the
casing.
Note: If engine does not start after 5 pulls, repeat instructions.
◆ After starting the engine, immediately squeeze and then
release throttle trigger to release fast idle throttle latch,
otherwise severe brake damage may occur.
◆ Never use fast idle throttle latch for cutting.
◆ Use the fast idle throttle latch only in starting.
Note: Do not increase engine speed while chain brake is locked.
Severe brake damage will result.
Starting Warm Engine
Make sure the bar and chain are free from any obstruction when
starting the chainsaw.
1. Move chain brake lever fully
FORWARD to LOCK chain brake
before starting.
2. Confirm there is fuel and chain
oil in the tanks.
To Next Page
Loading...
Need help?
General
