CS-3410 OPERATION
X7503361801 35
© 10/23 ECHO Incorporated
2. Move chain brake lever fully
REARWARD to UNLOCK chain
brake.
3. Squeeze throttle trigger (A)
gradually and increase engine
speed.
4. The chain starts running when
the engine reaches clutch
engagement speed (see
Specifications page).
5. Confirm proper acceleration and
lubrication of chain and bar.
6. Do not run the engine at high
speed unnecessarily.
7. Be sure that saw chain stops
moving when throttle trigger is
released.
Stopping
1. Release throttle trigger (A) and
allow engine to idle.
2. Push the momentary stop switch
(B) “DOWN” until the engine
stops.
Note: If engine does not stop,
pull choke control knob out
fully to stop engine.
Note: Return the unit to your
authorized dealer to check
and repair stop switch
before starting the engine
again.
To Next Page
Loading...
Need help?
General
