Echo CS-350WES Service Manual

CS-350WES
55
HANDLE AND CONTROL SYSTEM
9-3 Removing rear handle (continued)
5. Remove collar (E) from intake bellows (D).
6. Loosen nut securing switch (F) and remove
ignition switch (F) from rear handle (G). Remove
primer from rear handle and remove return pipe from
primer.
7. Push out intake bellows (D) and intake pipe (H)
to engine cover side to remove from rear handle.
NOTE: Do not use sharp tool to remove intake
bellows to prevent it from damage. If damage,
replace with new one.
8. Lifting rear handle a little, disconnect fuel pipe
(K) and connector of switch ground lead (L).
E
D
G
F
D
H
L
K
(continued)

Echo CS-350WES Specifications

General

Brand	Echo
Model	CS-350WES
Category	Chainsaw
Language	English