12
5. Lay unit on a at, clear area and keep bar and chain clear of
all obstacles. Hold top handle with one hand, and depress
throttle trigger lockout (C), but do not depress throttle trigger
(D).
6. Pull starter handle (F) several times until engine starts, or
rst starting sound is heard. (7 pulls maximum)
7. Move ignition/choke lever back to “run” ( I ) position (B).
(Do not move to “Stop” position [G].) If necessary, start the
engine.
NOTE
If engine does not start after 3 pulls with choke in “run” ( I )
position, repeat cold start instructions 4-7.
8. After engine starts, wait 5 seconds then depress and release
throttle trigger (D). Allow unit to warm up at idle for several
minutes.
NOTE
Do not pull starter rope out to the maximum possible position.
Do not allow recoil handle to snap back against the casing.
D
E
C
F
B
C
STARTING COLD ENGINE
WARNING
Make sure bar and chain are not touching anything when start-
ing the saw.
1. Move chain brake lever (E) fully forward to lock chain brake
before starting.
2. Fill the fuel tank with fuel. Do not over ll.
3. Fill the chain oil tank with lubricant. Do not over ll.
4. Move ignition/choke lever (A) forward to “close choke” (
)
position.
A
C
G
E
C
To Next Page
Loading...
Need help?
General
