Echo CS-360TES

Questions and Answers:

R
riggsryanAug 9, 2025
What to do if my Echo Chainsaw engine dies or accelerates poorly?
- E
  Erika MartinAug 10, 2025
  If your Echo Chainsaw engine runs but then dies or accelerates poorly, it could be due to several reasons. The air filter, fuel filter, or fuel vent might be dirty or plugged, requiring cleaning or replacement. The spark plug could need cleaning, adjustment, or replacement. The carburetor may need adjustment. Additionally, a plugged cooling system or exhaust port/silencer could be the cause, and these would need to be cleaned.
M
Michele CisnerosAug 14, 2025
How to fix an Echo Chainsaw that is hard to start?
- M
  maria17Aug 15, 2025
  If your Echo Chainsaw engine is hard to start or doesn't start, it could be due to a few reasons. There might be a fuel issue at the carburettor, in which case you should clean or replace it. Alternatively, the fuel line could be clogged and needs cleaning. If the problem persists, consult your ECHO dealer about the carburetor.
T
Timothy MartinAug 25, 2025
Why is there no spark at the plug on my Echo CS-360TES Chainsaw?
- D
  David AllenAug 26, 2025
  If there is no spark at the plug of your Echo Chainsaw, the spark gap might be incorrect and needs adjustment to 0.6 to 0.7 mm. The plug could also be covered with carbon or fouled with fuel, requiring cleaning or replacement. Finally, the spark plug itself might be defective and need replacement.
T
thomasfischerAug 29, 2025
What to do if the silencer on my Echo CS-360TES is wet with fuel?
- T
  tylerjensenAug 29, 2025
  If the silencer of your Echo Chainsaw is wet with fuel, it indicates that the fuel mixture is too rich. To resolve this, open the choke.
W
william51Sep 4, 2025
Why is the saw chain rotating at idling speed on my Echo CS-360TES Chainsaw?
- C
  crystal35Sep 4, 2025
  If you observe the saw chain rotating at idling speed on your Echo Chainsaw, it could be related to the carburettor or a damaged/binded clutch. For these issues, it's recommended to seek assistance from your ECHO dealer.
M
maciaschristopherSep 10, 2025
What to do if there's a spark at the plug wire but my Echo Chainsaw won't start?
- S
  Sara MontesSep 12, 2025
  If there is a spark at the end of the plug wire of your Echo Chainsaw but the engine isn't starting, check if the ignition switch is off and turn it on.