CS-501P OPERATION
X7503312804 31
© 01/20 ECHO Incorporated
◆ After choke control knob is pulled and then knob is
returned to original position, throttle remains slightly open
(fast idle latch condition).
◆ The chain will attempt to move when engine is started with
fast idle throttle latch engaged.
◆ Do not start engine before chain brake is locked.
7. Securely hold the chain saw and
pull starter handle (E) several
times until first starting sound.
8. Push choke control knob (C) all
the way IN (OPEN choke
position).
9. Pull starter handle (E) to start the
engine.
Note: Do not pull starter rope out to the maximum possible position.
Do not allow starter handle to snap back against the casing.
If engine does not start after 5 pulls, repeat instructions.
◆ After starting the engine, immediately squeeze and then
release throttle trigger to release fast idle throttle latch,
otherwise severe brake damage may occur.
◆ Never use fast idle throttle latch for cutting.
◆ Use the fast idle throttle latch only in starting.
10. When engine starts, immediately
squeeze and release throttle
trigger (F) to disengaging throttle
latch (G) and returning engine to
idle. Pull front hand guard (A)
towards the operator
immediately. (Chain brake
unlocked position).
Note: Do not increase engine
speed while chain brake (A) is locked. Severe brake damage
will result.
To Next Page
Need help?
General
