EasyManua.ls Logo

Echo shindaiwa CS-501SX

Echo shindaiwa CS-501SX
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Ref. No. 401-42
CS-501SX
CS-501SXH
ECHO:
shindaiwa:
501sx
(Serial number: 37000001 and after)
(Serial number: 38000001 and after)
Copyright C 2019 YAMABIKO Corporation All rights reserved.

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Echo shindaiwa CS-501SX and is the answer not in the manual?

Echo shindaiwa CS-501SX Specifications

General IconGeneral
Engine Type2-stroke
Engine Displacement50.2 cc
Fuel Tank Capacity0.53 L (18.0 fl. oz)
Oil Tank Capacity300 ml
Chain Pitch0.325"
Sound Power Level115 dB
Bar Length18 inches
Oil Capacity300 ml

Summary

Service Information

Specifications

Details technical specifications for the chainsaw models.

Technical Data

Provides key technical data and measurements for performance.

Torque Limits

Lists specified torque values for various fasteners during assembly.

Service Limits

Defines maximum wear limits for critical engine components.

Starter System

Disassembling Starter Assembly

Step-by-step guide for taking apart the starter mechanism.

Assembling Starter

Procedure for correctly reassembling the starter system components.

Ignition System

Troubleshooting Guide

Diagnostic flowchart for ignition system issues.

Testing Spark

Procedure to check for spark generation from the ignition system.

Fuel System

Adjusting Carburetor

Comprehensive guide for adjusting carburetor settings.

Installing Carburetor

Steps for correctly installing the carburetor.

Clutch System

Inspecting Clutch Parts

Procedure for inspecting clutch shoes, springs, and drum.

Installing Clutch Assembly

Guide for correctly installing the clutch assembly onto the crankshaft.

Engine

Testing Cylinder Compression

Method for measuring cylinder compression pressure.

Testing Crankcase and Cylinder Seal

Procedure to test the crankcase and cylinder for air leaks.

Inspecting Piston and Piston Ring

Checks for wear or damage on the piston and piston rings.

Assembling Crankshaft and Crankcase

Procedure for reassembling the crankshaft and crankcase.

Installing Piston Ring and Cylinder

Steps for fitting piston rings and installing the cylinder.

Rear Handle and Control System

Inspecting Heated Handle

Checks stator assembly and front handle heater for proper operation.

Maintenance Guide

Troubleshooting Guide

Diagnostic guide for common engine and system problems.

Service Intervals

Recommended maintenance schedule and intervals.

Related product manuals