STARTER SYSTEM
CS-501SX, CS-501SXH
501sx
8
WARNING DANGER
Wear eye protection and take care when
removing starter drum. Rewind spring may
unwind suddenly and cause personal injury.
A
B
C
B
D
b
2-1 Disassembling starter assembly
1. Remove four screws and remove starter assem-
bly (A) from unit.
2. Pull out starter rope about 30 cm (12 in) and
hold rope reel (B) by hand. Loop excess rope in
rope reel notch (b) as shown.
3. Rotate rope reel (B) counterclockwise to release
tension of rewind spring.
4. Remove bolt (C).
5. Remove rope reel (B) and rewind spring case (D)
with rewind spring.
6. Carefully remove rewind spring and case (D)
as one piece. Rewind spring is under tension and
may release unexpectedly.
To Next Page
Loading...
