Echo shindaiwa CS-501SX - Replacing Cushions

REAR HANDLE AND CONTROL SYSTEM
CS-501SX, CS-501SXH
501sx
59
9-1 Replacing cushions
1. Remove four cushion caps (A) (Refer to cushion
caps (J) of “9 REAR HANDLE AND CONTROL
SYSTEM”on previous page).
2. Remove a bolt (B), four cushion caps (A), four
bolts (C) under cushion caps (A) and rear handle
from unit.
3. Inspect cushions (D) for cracking and wear. If
damaged replace with new cushions as follows.
4. To remove cushions (D), push by hand in direc-
tion of arrows.
5. Install new cushions by pushing in direction of
arrows.
A
D
A
A
B
C
under cushion cap