6
EMISSION CONTROL
EPA Phase 2
The emission control system for these engines is EM/TWC (Engine and Catalyst Modification).
IMPORTANT ENGINE INFORMATION
ENGINE FAMILY: 6EHXS.0214KI DISPLACEMENT: 21.2 CC
EMISSION COMPLIANCE PERIOD : 300 HRS.
THIS ENGINE MEETS U.S. EPA PH2 AND 2005 - 2006 CALIFORNIA
EMISSION REGULATIONS FOR SORES. REFER TO OWNER'S
MANUAL FOR MAINTENANCE SPECIFICATIONS AND ADJUST-
MENTS.
EQUIPMENT CHECK
WARNING DANGER
Use only ECHO approved attachments. Serious injury may result from the use of a non-approved attachment
combination. ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which
have not been tested and approved by ECHO. Read and comply with all safety instructions listed in this manual and
safety manual.
• Check unit for loose/missing nuts, bolts, and screws. Tighten and/
or replace as needed.
• Inspect fuel lines, tank, and area around carburetor for fuel leaks.
DO NOT operate unit if leaks are found.
• Check that the cutting attachment is firmly attached and in safe
operating condition.
Emission Control Label (located on Engine) (EXAMPLE ONLY,
information on label varies by FAMILY).
PRODUCT EMISSION DURABILITY
The 300 hour emission durability compliance period is the time span selected by the manufacturer certifying the
engine emissions output meets applicable emissions regulations, provided that approved maintenance procedures are
followed as listed in the Maintenance Section of this manual.
To Next Page
Loading...
