HC-2210 / 2810 OPERATION
X7702248101 23
© 10/21 ECHO Incorporated
Starting Warm Engine
The starting procedure is the same as Cold Start except DO NOT close the
choke.
The blades must not move at idle, otherwise serious personal
injury may result. Periodic carburetor adjustment may be
necessary to assure blades do not move at idle. If blades move,
readjust carburetor according to “Carburetor Adjustment”
instructions in this manual or see your dealer.
1. Stop Switch
Move stop switch (A) away from
the STOP position.
2. Purge Bulb
Pump purge bulb (C) until fuel is
visible and flows freely in the
clear fuel tank return line. Pump
bulb an additional 4 or 5 times.
3. Recoil Starter
Place the unit on a flat, clear
area. Grip the support handle
securely with one hand, and pull
the recoil starter handle (D) until
engine starts.
Note: If engine does not start
after 2-3 pulls, use Cold
Start Procedure.
To Next Page
Loading...
