HC-2210 / 2810 OPERATION
X7702248101 25
© 10/21 ECHO Incorporated
To operate
1. Fully release throttle trigger.
2. Push handle release lever.
3. Rotate the handle 90° in the
desired direction and release
the lever. Make sure that the
handle is fully locked into
position before use.
Note: The throttle trigger will not
operate when the throttle
handle is not fully locked
into position.
Hedge Trimming
Hedge Trimmer blades are very sharp. Touching them may lead
to severe personal injury. Avoid touching blades whenever
possible, and always wear gloves to protect hands.
1. Always grip support handle with
right hand, and throttle handle
with left hand.
2. Hold trimmer firmly and
squeeze throttle trigger to
accelerate engine.
3. Tilt trimmer so cutting teeth are
angled slightly toward the
hedge or shrub and proceed to
cut.
Never remove hands from unit when blades are moving.
The engine continues running even when the blades have
stopped due to an obstruction. If this occurs, stop the engine,
disconnect ignition cable and remove the obstruction.
To Next Page
Loading...
