PRO ATTACHMENT SERIES
TM
OPERATOR'S MANUAL
15
AIR FILTER
Level 1.
Tools required: 25 or 50 mm (1 or 2 in.) medium bristle paint brush
Parts required: 90030 REPOWER
TM
Air and Fuel Filter Kit
1. Close choke (Cold Start Position). This prevents dirt from entering
the carburetor throat when the air filter is removed. Brush accumu-
lated dirt from the air cleaner area.
2. Remove the air cleaner cover. Clean and inspect the element for
damage. If element is fuel soaked and very dirty, replace.
3. If element can be cleaned and reused, be certain it:
•still fits the cavity in the air cleaner cover.
•is installed with the original side out.
FUEL FILTER
Level 1.
Tools required: 200-250 mm (8-10 in.) length of wire with one end bent
into a hook, Clean rag, funnel, an approved fuel
container
Parts required: 90030 REPOWER
TM
Air and Fuel Filter Kit
WARNING DANGER
Fuel is VERY flammable. Use extreme care when mixing, storing or
handling, otherwise serious personal injury may result.
1. Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2. Use the “fuel line hook” to pull the fuel line and filter from the tank.
3. Remove the filter from the line and install the new filter.
To Next Page
Loading...
Need help?
General
