13
Power Blower
oPerator's Manual
sTarTIng Cold engIne
• Recoil starter: Use short pulls - only 1/2-2/3 of rope length for start-
ing. Do not allow the rope to snap back in. Always hold the unit
rmly.
• Rotate throttle handle downward to a comfortable operating position.
1. Throttle Position Lever
Move throttle position lever (A) to START/IDLE DETENT posi-
tion(
).
2. Choke
Move choke (B) to "Cold Start" (
) position.
3. Purge Bulb
Pump purge bulb (C) until fuel is visible and ows freely in the
clear fuel tank return line.
4. Recoil Starter
Pull recoil starter handle (D) until engine res, or maximum 5
pulls.
5. Choke
Move choke (B) to run (
) position and if necessary, restart
engine.
NOTE
If engine does not start after 5 pulls, repeat instructions 2-5.
NOTE
Allow engine to warm up before use.
D
B
A
C