To Next PageTo Next PageHow to fix an Echo PB-500H that runs but doesn't blow properly?
If the engine of your Echo Blower runs, but the blower doesn't work or is weak/uneven, check the following: * The pipe might be clogged; unclog it. * The pipe could be loose; tighten it. * The pipe might be damaged; replace it.
Why my Echo PB-500H starts hard?
Your Echo Blower may start hard due to several reasons: * There might be no fuel reaching the carburetor, in which case you should clean or replace it. * If the muffler is wet with fuel, open the choke, clean or replace the air filter, or adjust the carburetor. * If there is no spark, ensure the switch is turned ON, or adjust to .65mm (0.026 in.), clean or replace the spark plug.
What to do if Echo Blower engine runs, but dies?
If your Echo Blower engine runs but dies or doesn't accelerate properly, consider these potential issues: * A dirty air filter could be the cause; try cleaning or replacing it. * The fuel filter might be dirty, requiring replacement. * A plugged fuel vent could also be the culprit; clean or replace it. * Additionally, a dirty or worn spark plug may need cleaning, adjustment, or replacement. * Improper carburetor adjustment can also cause this issue, so adjust accordingly. * Check if the cooling system is dirty or plugged and clean it. * Finally, a plugged spark arrestor screen should be replaced.
General| Engine Type | 2-stroke |
|---|---|
| Type | Handheld |
| Carburetor | Diaphragm |
| Ignition System | Electronic |
| Starter System | Recoil |
| Noise Level | 70 dB(A) |
| Blower Type | Backpack |
